Interior and Exterior Use

It will polish back the original appearance that the stone once had. It works on floors, walls, vanities, tables and columns.

Recommendations:

Always test on a small area before using.

Natural stone should be protected with SOLVENT BASED SEALER or WATER BASED SEALER.

Follow the recommended Chemspec cleaning procedures for STONE FLOOR CLEANER & STONE COUNTERTOP CLEANER.

If heavy abrasions or scratches are on the surface, use HONING POWDER prior to using the polishing cream.

If scratches are deep and severe, contact a professional stone restoration company.

Cover all surfaces that are not stone.

Always wear potective clothing such as safety goggles, gloves, and footwear.

Always work small areas at a time until you become familiar with the product.

Adding more water can help eliminate hazing on black marble.

In the event of medical emergency, call 1-800-424-9300.

Always use protective gloves when applying by hand.

MINERAL DEPOSIT REMOVER contains a small amount of petroleum distillates.

Do not smoke when using.

Directions for Use:

MARBLE COUNTERTOPS, TABLETOPS, VANITIES, WALLS:

Clean the surface with STONE COUNTERTOP CLEANER.

Shake the MINERAL DEPOSIT REMOVER until the product thickens. (Keep shaking the bottle after each use).

Add a few small drops of water to the damaged area and then apply a dab of MINERAL DEPOSIT REMOVER to the dull or damaged area.

With a piece of red buffing pad or a clean, damp white terry cloth towel, begin buffing in a circular motion. (Red buffing pads will provide a better result due to its polishing nature).

Wipe off when desired appearance is attained.

Rinse with STONE COUNTERTOP CLEANER.

Protect the surface with COUNTERTOP/WALL POLISH. The same process can be used for small floor areas, but do not apply the COUNTERTOP/WALL POLISH to any floor surface.

MARBLE FLOORS (Using a 175 rpm Buffing Machine):

MINERAL DEPOSIT REMOVER should be used with a hogs hair pad or red buffing pad.

Approximate usage is one ounce per five square feet.

Be sure to remove all coatings, dust and loose sediment from the surface prior to applying MINERAL DEPOSIT REMOVER.

Apply three inches of MINERAL DEPOSIT REMOVER to the worn surface, spray water over the MINERAL DEPOSIT REMOVER, and begin buffing directly into the floor with 175-rpm's. The cream should remain pasty throughout the buffing process.

Buff until the haze is completely gone and a natural shine appears on the floor.

Rinse the floor immediately with STONE FLOOR CLEANER.